MIL-DTL-14824C(AR)
Level II for all Minor characteristics; Critical characteristics
shall be addressed in accordance with MIL-STD-1916.
b. Conformance inspection. Conformance inspection shall be
performed in accordance with paragraph 4.3.2.1 through 4.3.2.6.
For all conformance inspections the same sample specimen may be
used for all non-destructive examinations or tests.
c. Alternative Inspections. Alternative conformance
inspections may be submitted and approved in accordance with MIL-
STD-1916.
d. Tool control. Dimensions marked tool control shall be
gaged at the beginning of production and whenever tooling is
replaced. Where destruction of components is necessary to
inspect these dimensions, measurements of the tool may be
substituted provided there is an established correlation between
the tool dimensions and the component dimensions prior to the
start of production. There shall be adequate surveillance to
assure that the drawing requirements are being met throughout the
life of the tool.
13
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business